The Mackie SRM450 v2 PA Speakers retain the best of the original SRM design, including Mackie signature Active architecture and its renowned rugged durability. With ultra-efficient switching power supplies, a lightweight neodymium woofer, an all-new compression driver and Class-D Fast Recovery amplification (300W LF/100W HF), the SRM450v2 packs way more power, clarity and punch. Its wide dispersion, outstanding bass extension and ultra-low distortion mean the SRM450v2 delivers pure studio monitor fidelity at full-on loudspeaker levels. The Mackie SRM450v2 Active loudspeaker combines superior quality with innovative technology to bring ultimate performance and reliability to the legendary Sound Reinforcement Monitor (SRM) series.

Features

2-way bi-amplified, optimized active loudspeaker system
High-output precision titanium compression driver
Neodymium long-throw low frequency transducer with 3-inch voice coil
Servo Feedback controlled woofer for tight low-end punch
300W class-D, Fast Recovery LF amp / 100W HF amp
Ultrawide, smooth dispersion via multi-cell horn aperture and HF waveguide
Built-in phase-accurate 24dB Linkwitz-Riley electronic crossover
Mackie Active Electronic time alignment, phase correction and EQ for studio quality sound
Mic/line input and pass-thru connector
Lightweight for ultimate portability (40 lbs)
Flyable, Pole Mountable, Floor Wedge-able

Specifications

Input Type: Balanced Differential
Input Impedance, Line: 20k ohms
Input Protection: RFI and level protected
Sensitivity Line: +4 dBu (center detent), Mic: -36 dBu
Maximum Input Level, Line: +22 dBu
Low-Cut Frequency: 75Hz, Second-order filter
Acoustic Contour Equalization Peaking:
+3 dB @ 100Hz
+3 dB @ 12kHz
Enclosure Alignment: Sixth-Order
Over-Excursion Protection: second-order, high-pass filter
Thermal Protection: Amplifier shutdown, auto reset
Low-Line Voltage Shut Down: 60% Nominal line
Frequency Range (-10 dB): 45Hz - 20KHz
Frequency Response (±3 dB) 55Hz - 18kHz
Maximum Peak SPL @ 1m: 127dB
Low-Freq Crossover: 24 dB/octave, time offset corrected
High-Freq Crossover: 24 dB/octave
Crossover Frequency: 1.6kHz
Driver Protection: independent LF and HF compressors
Low-Freq Roll-Off: dynamic-signal level dependent
Accessory Interface ±15V DC, normalized signal I/O
Operating Temperature Range: -10°C to 45° C (14°F to 113°F)
Transducer Low-Frequency Transducer: Diameter 300mm (12") Power Handling 450 watts RMS Frequency Range 45Hz - 3kHz
Hi-Frequency Driver and Horn: Diaphragm Diameter 44mm (1.75") Exit Throat Diameter 25mm (1") Diaphragm Material Titanium Sensitivity (1W@1m) 106 dB Power Handling 100 watts RMS Frequency Range 1kHz - 20kHz Horn Type Composite: Exponential and Conical Mouth Size 305mm (12") W x 178mm (7") H
Horn Coverage : Horizontal Coverage 90° Vertical Coverage 45° _ Power Amplifier and System Low-Frequency Power Amplifier: Rated Power 300 watts RMS Rated THD < 0.1% Cooling Convection Extrusion Design Class G, Parametric Servo Feedback
High-frequency amplifier: Rated Power 100 watts @ High-Frequency Driver Impedance Rated THD < 0.1% Cooling Convection Extrusion Design Conventional Class AB